2N PRI Gateways - User Manual - Manual (Page 92)

90
12. APPENDIX B – LIST OF ALL STATUS CODES
12.1.1. Plug-In Boards
Board Types
ID Name
Description
0
NONE
(no board)
1
CPU111 (CPU board is not displayed)
2 PRI130 1x PRI port NT/TE
3 GSM160 2x GSM Ericsson GM22 module + 2x SIM
4 AUX120 Switch matrix, voice message generator and AUX port
5 GSM161 2x GSM Siemens TC35 module + 8x SIM
Board Types
ID Name
Description What Follows
0 INIT HW board reset and init of respective SW parts in
progress OK/CHECK
1 ERROR Board in wrong slot or defective board HW board reset
2 POWER Only upon system power on or AT!Bxx=RESET
command DETECT
3 OK Rest status, HW is working on board (full
operation) DISC
4 UNDEF Empty slot DETECT
5 CHECK Board firmware check (AUX only) ERASE
6 ERASE Board firmware erasing (AUX only) PROF
7 PROG New board firmware loading (AUX only) OK
8 DETECT New board plug-in detected INIT
9
DOWN
Frozen status, HW is working on board but no
new calls are started board reset
10 MODEM0 Parameter S80 sent to modem (AUX only) MODEM1
11
MODEM1 Parameter S81 sent to modem (AUX only)
OK
12
DISC
Board plug-out detected UNDEF
12.1.2. ISDN
Layer Statuses
ISDN Layer 1 Statuses
ID Name
Description
0
DEACT Deactivation – no signal received
1 ACTIVE Activation – full synchronization achieved (frame,multiframe,crc)
2 SIGNAL Signal received – no synchronization
3 SYNC Signal received – only partial synchronization (frame)
ID Name
Name According to Q.921
0 NOTEI TEI Unassigned
1 AWTEI Assigned Awaiting TEI
2 AWTEST Establish Awaiting TEI
3 OKTEI TEI Assigned
4 AWEST Awaiting Establishment
5 AWREL Awaiting Release
6 OKEST Multiple Frame Established
7
TIMREC Timer Recovery