AirLive SNMP-24MGB - Manual (Page 197)

5. CLI Management in SNM-24MGB
AirLive SNMP-24MGB v2 User’s Manual 190
Syntax:
logout
Description:
When you enter this command via Telnet connection, you would logout the system and
disconnect. If you connect the system through direct serial port with RS-232 cable, you
would logout the system and be back to the initial login prompt when you run this
command.
Argument:
None.
Possible value:
None.
Example:
SNMP-24MGB# logout
restore default
Syntax:
restore default
Description:
When you use this function in CLI, the system will show you the information “Do you want to
restore the default IP address?(y/n)”. If you choose Y or y, the IP address will restore to
default “192.168.1.1”. If you choose N or n, the IP address will keep the same one that you
had saved before.
If restoring default successfully, the CLI would prompt if reboot immediately or not. If you
press Y or y, the system would reboot immediately; otherwise, it would be back to the CLI
system. After restoring default configuration, all the changes in the startup configuration
would be lost. After rebooting, the entire startup configuration would reset to factory default.
Argument:
None.
Possible value:
None.
Example:
SNMP-24MGB # restore default