AirLive SNMP-24MGB - Manual (Page 31)

4. Web Management in SNMP-24MGB
AirLive SNMP-24MGB v2 User’s Manual 24
Daylight saving is adopted in some countries. If set, it will adjust the time lag or in
advance in unit of hours, according to the starting date and the ending date. For
example, if you set the day light saving to be 1 hour. When the time passes over
the starting time, the system time will be increased one hour after one minute at
the time since it passed over. And when the time passes over the ending time, the
system time will be decreased one hour after one minute at the time since it
passed over.
The switch supports valid configurable day light saving time is –5 ~ +5 step one
hour. The zero for this parameter means it need not have to adjust current time,
equivalent to in-act daylight saving. You don’t have to set the starting/ending date
as well. If you set daylight saving to be non-zero, you have to set the
starting/ending date as well; otherwise, the daylight saving function will not be
activated.
Default for Daylight Saving: 0
.
The following parameters are configurable for the function Daylight Saving and
described in detail.
Day Light Saving Start :
This is used to set when to start performing the day light saving time.
Mth: Range is 1 ~ 12; Default: 1
Day: Range is 1 ~ 31; Default: 1
Hour: Range is 0 ~ 23; Default: 0
Day Light Saving End :
This is used to set when to stop performing the daylight saving time.
Mth: Range is 1 ~ 12; Default: 1
Day: Range is 1 ~ 31; Default: 1
Hour: Range is 0 ~ 23; Default: 0
4.2.4 IP Configuration
It is one of the most important configurations in the switch. Without the proper setting,
network manager will not be able to manage or view the device. The switch supports both
manual IP address setting and automatic IP address setting via DHCP server. When IP
address is changed, you must reboot the switch to have the setting taken effect and use the
new IP to browse for web management and CLI management.
Function name: