AirLive SNMP-24MGB - Manual (Page 45)

4. Web Management in SNMP-24MGB
AirLive SNMP-24MGB v2 User’s Manual 38
Parameter Description:
Port:
Display the port number. The number is 1 – 24.
Link:
Show that if the link on the port is active or not. If the link is connected to a
working-well device, the Link will show the link “Up”; otherwise, it will show “Down”.
This is determined by the hardware on both devices of the connection. No default
value.
Speed / Duplex Mode:
Display the speed and duplex of all port. There are three speeds 10Mbps,
100Mbps and 1000Mbps supported for TP media, and the duplex supported is half
duplex and full duplex. If the media is 1Gbps fiber, it is 1000Mbps supported only.
The status of speed/duplex mode is determined by 1) the negotiation of both local
port and link partner in “Auto Speed” mode or 2) user setting in “Force” mode. The
local port has to be preset its capability. Default is None, depends on the result of
the negotiation.
Flow Control:
Show each port’s flow control status.
There are two types of flow control in Ethernet, Backpressure for half-duplex
operation and Pause flow control (IEEE802.3x) for full-duplex operation. The
switch supports both of them. Default is None, depends on the result of the
negotiation.
Description:
Network managers provide a description of device ports.