AirLive SNMP-24MGB - Manual (Page 115)

4. Web Management in SNMP-24MGB
AirLive SNMP-24MGB v2 User’s Manual 108
Function name:
ACE Configuration
Function description:
The switch ACL function support up to 128 Access Control Entries (ACEs), using the
shared 128 ACEs for ingress classification. You can create an ACE and assign this
ACE for each port with <Any> or assign this ACE for a policy or assign this ACE for a
port. There are 8 policies, each port can select one of policy, then decides which of
the Permit/Deny, Rate Limitation and Port Copy actions would take according to the
ACL configuration packet’s IPv4, EtherType, ARP Protocol, MAC Parameters and
VLAN parameters.
Parameter description:
Ingress Port:
Range: Any / Policy 1-8 / Port 1-24
Any: Apply this ACE rule for each port ingress classification
Policy 1-8: Apply this ACE rule for specific policy
Port 1-24: Apply this ACE rule for specific port ingress classification
IP Protocol Filter:
Range: Any / Ethernet Type / ARP / IPv4
Any: It is including all frame type
Ethernet Type: It is including all Ethernet frame type
ARP: It is including all ARP protocol frame type
IPv4: It is including all IPv4 protocol frame type
MAC Parameters: (When Frame Type = Any)
DMAC Filter:
Range: Any / MC / BC / UC
Any: It is including all destination MAC address
MC: It is including all Multicast MAC address
BC: It is including all Broadcast MAC address
UC: It is including all Unicast MAC address
MAC Parameters: (When Frame Type = Ethernet Type)
SMAC Filter:
Range: Any / Specific
Any: It is including all source MAC address
Specific: It is according to SMAC Value specific the source MAC address