Lenze MC3000 Series - Manual (Page 43)

13435743_EDBM301_v14 .0 39
16 .2 PARAMETER ACCESS USING SPEED DIAL
SPEED DIAL is used to access parameters quickly using the parameter number . Once
accessed, the parameter can be programmed as described in Section 16 .1 . SPEED
DIAL is accessed by pressing the AUTO/MAN key while in the PROGRAM mode . This
will activate the SPEED DIAL display as shown below:
- SPEED DIAL -
Once in SPEED DIAL, the p and q keys will allow the operator to scroll through the
parameter numbers . The display will continue to show SPEED DIAL while scrolling through
the parameter numbers, as shown below:
#11 SPEED DIAL
When the desired parameter is reached, the SPEED DIAL display will be replaced by
the parameter name:
#11 MAX FRQ
Once the desired parameter is displayed on the screen, press the ENTER key to display
the parameter name and present setting . The parameter setting can now be changed by
the method described in Section 16 .1 . Press the AUTO/MAN key to return to SPEED DIAL .
NOTE
SPEED DIAL is only active in MC3000 drives which have the Modbus
serial communications protocol . Units that have the Metasys protocol
do not have this feature .