Lenze ECSEExxx - Manual (Page 56)


56 EDKCSEE040 DE/EN/FR 4.0
Scope of supply
Position Description Number
 Power supply module ECSEExxx 1
 Accessory kit with attachment material 1
Mounting instructions 1
Drilling jig 1

Note!
The ECSZE000X0B connector set must be ordered separately.
Connections and interfaces
Position Description Detailed
information
X22 Connections
 External brake resistor
 DC-bus voltage

PE
 87
 LEDs: Status and fault display
X1 Automation interface (AIF) for

Communication module

Operating module (XT keypad)
 101
X2 PE connection AIF
X3 Not assigned
X4 CAN connection

System bus (CAN)

Interface for
– master control and other modules
– PC/HMI for parameterisation and diagnostics
 102
X6 Connections

Low-voltage supply

Digital inputs and outputs

Thermostat contacts
 100
S1 DIP switch

CAN node address (device address in the CAN network)

CAN baud rate
X21 Mains connection  84
Status displays
LED Description
Red Green
Off On Power supply module is enabled, no fault
Off Blinking Power supply module is inhibited (CINH), switch-on inhibit
Blinking, 1 Hz Off Fault / error (TRIP) / short-circuit braking error (KSB-TRIP) is active
Blinking, 3 Hz Off Message active
Blinking, 1 Hz Blinking Warning active with inhibited module
Blinking, 1 Hz On Warning active with enabled module