Lenze ECSEExxx - Manual (Page 61)

Safety instructions
General safety and application notes for Lenze power supply modules
1

61 EDKCSEE040 DE/EN/FR 4.0
ƒ High amounts of energy are produced in the power supply module.
Therefore it is required to wear personal protective equipment (body
protection, headgear, eye protection, ear protection, hand guard).
Application as directed
Power supply modules are components which are designed for installation in
electrical systems or machinery. They are not to be used as domestic appliances,
but only for industrial purposes according to EN 61000-3-2.
When installing the power supply modules in machines, commissioning (i.e.
startingof operationasdirected)is prohibiteduntil itis proventhat themachine
complies with the regulations of the EC Directive 2006/42/EC (Machinery
Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when
there is compliance with the EMC Directive (2004/108/EC).
The power supply modules meet the requirements of the Low-Voltage Directive
2006/95/EC. The harmonised standard EN 61800-5-1 applies to the power
supply modules.
The technical data as well as the supply conditions can be obtained from the
nameplate and the documentation. They must be strictly observed.
Warning: The power supply modules are products which can be installed in
drive systems of category C2 according toEN 61800-3. Theseproducts cancause
radio interference in residential areas. In this case, special measures can be
necessary.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The power supply modules must be installed and cooled according to the
instructions given in the corresponding documentation.
The ambient air must not exceed the degree of pollution 2 according to
EN 61800-5-1.
Ensure proper handling and avoid excessive mechanical stress. Do not bend any
components and do not change any insulation distances during transport or
handling. Do not touch any electronic components and contacts.
Power supply modules contain electrostatically sensitive components which
can easily be damaged by inappropriate handling. Do not damage or destroy
any electrical components since this might endanger your health!