Northern Connectors Harting HAN Industrial Rectangular Connectors - Manual (Page 294)

Han-
Brid
19
.
03
Han-Brid ® Data interfaces
Data interfaces
Han-Brid ® F.O.
• Is suitable for all HP Versatile Link (Horizontal
Package) transmitters and receivers
• Data rates: Standard 12 Mbit/s, suitable for all com-
mon fieldbus systems
• Insert allows integration of HP standard contacts for
POF and HCS ® * fibres
• Temperature range -40 °C ... +70 °C
Han-Brid ® Cu
• For termination of a shielded twisted pair
• Insert for 2x Han D ® male or female contacts
• Connection of the shield by means of shielding plate
and fixing clamps
• Connection of the device side can be realized either
by a printed circuit board as a modular version or as
part of the appliance PCB
• Insert for bulkhead mounted housing or the cou-
pling housing are always equipped with a screening
spring
Bus Terminator
• Active bus terminator in male and female version
• Standard Han ® 3 A hoods and housings
• Power supply to the termination network via electri-
cal contacts of Han-Brid ®
• Integrated, galvanically separated DC/DC converter
24 V / 5 V
Han-Brid ® Quintax 3 A
• Possibility to terminate shielded four/eight wires
conductors (2 pair STP)
• Possibility to terminate Coax cable with large
diameter
• Suitable for all 4-wire bus systems
• Suitable for shielded cable conductor diameter 3 – 9.5 mm
• Transmission of shielding separately from the
hood’s ground
• Connections are carried out acc. to DIN EN 50 173,
Cat. 5
• Temperature range -40 °C ... +70 °C
Han-Brid ® RJ45 C
• Suitable for standard RJ 45 Plug and Jack, shielded
version
• Connections provided for conductors acc. to
DIN EN 50 173, Cat. 5
• Termination from the device side is carried out via a
PCB, two versions are possible: modular version or
as part of the appliance PCB
• Assembly with standard tools
• Insert for 2 Han-D ® male or female contacts offers
the combination with electrical bus connector
• Rated current 10 A
• Rated voltage 24 V
• termination side 0.14 - 2.5 mm²
Han-Brid ® USB
• Insert for all Han ® 3 A hoods and housings
• Hood with glued sealing
• Simple and low-cost termination via insert of a patch
cable
• Strain-relief via cable tie
Han-Brid ® FireWire
• Insert for all Han ® 3 A hoods and housings
• Hood with glued sealing
• Simple and low-cost termination via insert of a patch
cable
• Strain-relief via cable tie
• Compatible to IEEE 1394
Han ® 4 A SC
• Suitable with housings, size Han ® 3 A including
versions Han ® M, Han ® EMV and Han ® HPR
• Degree of protection up to IP 68
• For fibre optic SC contacts; up to 4 SC contacts per
connector
• For 1 mm POF
• For Multimode fibre 50 - 62.5 / 125 µm and Single-
mode fibre 9 / 125 µm
• Full ceramic sleeves for a minimal insertion loss
* HCS ® Hard Clad Silica (is registered trade mark of the SpecTran Corporation)