Tools, Han- yellock, For contacts – Northern Connectors Harting HAN Industrial Rectangular Connectors User Manual
Page 496
99
.
08
Tools
Tools
for contacts
Han-Yellock
®
(11 05 ...)
Identification
Part number
Drawing
Dimensions in mm
Removal tool for crimp contacts
A removal tool is necessary if contacts are to be replaced in
the insert. The tool is inserted from the wiring side until a stop
is noticeable. The wire with the crimp contact can then be pul-
led out from the same side of the insert.
Panel punch
panel cut out tool
panel thickness
steel: ≤ 2.5 mm
stainless steel: ≤ 2 mm
for hydraulic pump
punch force: ≥ 60 kN
thread: 3/4“ UNF
for Han-Yellock
®
30
for Han-Yellock
®
60
Insertion tool for crimp contacts
For crimp contacts with wires of less than 0.75 mm² it is
recommended that an insertion tool is used. Contacts should
be inserted from the wiring side and pushed down until a
positive locking is achieved.
Stock items in bold type