RKI Instruments Data Cal 2000 - Manual (Page 33)

Setting Up the Data Cal 2000 Software • 28
Setting Up the Configuration
1. Launch the software as described in “Launching the Data Cal 2000
Software” on page 23.
NOTE: It is not necessary to turn on the Data Cal 2000 if you
are only performing configuration setup. With the Data
Cal 2000 off, the software will indicate communication
errors in the area below the docking module/instrument
display area. This is normal if the Data Cal 2000 is not
turned on.
2. From the main window, click on the Config button located along
the top of the window.
3. Enter the password and click OK. The default password is
“ABCDE” and is case sensitive. After clicking OK, the Configuration
Window is opened and the Parameter tab will be in the foreground.
Figure 17: Configuration Window