RKI Instruments Data Cal 2000 - Manual (Page 79)

Instrument/Module Function Menu • 74
mode (see below).
Edit Function
This function can be activated by either right clicking an instrument that is
connected to the Data Cal 2000 and selecting Edit(E) when the pull down
menu appears or by selecting an instrument that is connected to the Data
Cal 2000 and then using the alt/E key combination.
NOTE: The Edit function is not active and cannot be selected if
the Change Parameter selection box in the Instrument
Information section of the Configuration window
Parameter tab is not selected.
The Edit function brings up the Instrument Information window and
makes the items in the Parameter Setting and Sensor Setting tabs
available for updating. It also activates the Load Factory Defaults and
Figure 47: Instrument Information Window, Sensor Setting Tab