RKI Instruments Data Cal 2000 - Manual (Page 45)

Connecting Instruments to the Data Cal 2000 • 40
• A GX-2003 will begin its normal startup sequence and after a
few seconds, the pump will turn off and the display will indicate it
is ready to communicate with the computer:
• A GX-2001 will begin its normal startup sequence and after a
second or two the display will indicate the following:
7. The message window in the main program window will indicate
when each unit is connected to the program and what actions are
being taken, for example, parameter reading or automatic data
downloading. In Figure 22 below, one GX-2001, one GX-2003 and
one GX-2009 are connected to the Data Cal 2000 and their
parameters have been downloaded.
If the Data Cal 2000 software is setup for automatic bump testing or
automatic calibration, the software will determine if any connected
instruments require bump testing or calibration after their
parameters have been retrieved by the software and data has been
retrieved (if software is setup for automatic downloading), then
perform bump testing or calibration if necessary.
NOTE: If the software is setup for automatic data downloading,
it may take up to 10 minutes to download each GX-2001
if its memory is full, up to 20 minutes to download each
GX-2003 if its memory is full, and up to 25 minutes to
download each GX-2009.
PC
TRANSMIT
STAND BY
OK
21:09
Conn