RKI Instruments Data Cal 2000 - Manual (Page 37)

Setting Up the Data Cal 2000 Software • 32
Viewing the Pre-Defined Cylinders
1. From the main program window, click the Cylinders button located
along the top of the window. The Cylinders window appears.
The Cylinders window lists defined cylinders and has four function
buttons in the lower right corner of the window for adding, updating,
or deleting cylinders. When the software is first loaded, there are
two pre-defined cylinders on the list. One is a 58 liter 4-gas mix with
25 ppm H2S, 50 ppm CO, 50% LEL CH4, and 12% Oxygen, RKI
part number 81-0154RK-02. This cylinder is included with the Data
Cal 2000. The other is a 58 liter 50% volume CH4 cylinder, RKI part
number 81-0013RK-05, that is used to calibrate the %volume TC
sensor if it is installed in a GX-2003. The %volume CH4 cylinder is
not included with the Data Cal 2000 and must be ordered
separately.
2. If the pre-defined cylinders are sufficient for calibrating and bump
testing the instruments that will be used with the Data Cal 2000,
click the Close button to return to the main window and proceed to
“Setting Up the Solenoids” on page 36.
If the pre-defined cylinders are not appropriate for the instruments
that will be used with the Data Cal 2000, proceed to the next
section, "Adding and Updating Cylinders".
Figure 18: Cylinders Window