Setup mode – RKI Instruments Eagle Series User Manual
Page 32
Diffusion Eagle Instruction Manual
Setup Mode • 27
Setup Mode
NOTE: The screens illustrated in this section are examples only. The screens
displayed by your Eagle model may be slightly different.
The Eagle has four operating modes: normal operating mode, display mode,
setup mode, and calibration mode. This section describes the setup mode. In
setup mode, you can:
•
update the battery type setting
•
update channel settings
•
update the combustible gas channel’s units of measure
•
update the alarm point settings
•
update the Eagle’s serial number
•
turn the lunch break function on or off
•
update the alarm latching setting
•
update the alarm silence setting
•
turn the user ID function on or off
•
update the auto calibration settings
•
update the back light setting
•
turn the auto fresh air function on or off
•
update the data interval time setting (data logging option only)
•
update the log data over write setting (data logging option only)
•
update the time calibration setting (data logging option only)
•
update the date and time settings (data logging option only)
•
turn the zero follower on or off for each channel
•
turn the confirmation beep on or off
•
return to default settings (three default options)
The Eagle is pre-set to suit most applications. Follow these instructions only
if required.