RKI Instruments Eagle Series - Manual (Page 42)

Diffusion Eagle Instruction Manual Setup Mode • 37
If this is the alarm point you want to update, continue with step 3. If not,
continue pressing the POWER/ENTER button until the correct set alarm
point screen displays, then continue with step 3.
3. Use the AIR/ ▲ and SHIFT/ ▼ buttons to display the desired setting.
4. Press the POWER/ENTER button to enter the new alarm point and scroll
to the next set alarm point screen. (Repeat step 3 and 4 to update another
alarm point for this channel.)
5. Press the POWER/ENTER button to scroll to the last set alarm point
screen for this channel, then press the POWER/ENTER button again to
return to the Set Alarm Points menu.
6. Repeat steps 2 through 5 until all desired alarm points are updated. Make
sure you return to the Set Alarm Points menu to continue.
7. To exit the Set Alarm Points menu, press the SHIFT/ ▼ button until the
prompt is next to Channel 4, then press the SHIFT/ ▼ button again. The
ESCAPE message displays. (Press the AIR/ ▲ button if you want to return
to the Set Alarm Points menu.
8. Press the POWER/ENTER button to save the settings and return to the
main menu.
Updating the Eagle’s Serial Number
Every Eagle is programmed with a unique serial number. The data logging
option includes the serial number in its log data for identification purposes.
The serial number setting accepts numeric (0 through 9) and alpha (A
through Z) characters.
NOTE: The serial number is factory set and should not need to be changed.
However, if you “reset all defaults,” the serial number is reset to
******.
1. From the main menu, select the SERIAL NO. menu option.
2. Press the AIR/ ▲ and SHIFT/ ▼ buttons to display the desired character,
then press the POWER/ENTER button to enter the character. The next
character flashes.
3. Repeat step 2 to enter the remaining characters. The main menu displays
after you enter the last character.
S E
X
E N
T
L R o I A
# #
S
# # #