RKI Instruments SDM-2012 Standalone Configuration - Manual (Page 13)

Instrument Panel • 8
Instrument Panel
The instrument panel is on the top of the SDM-2012 and includes the instrument
cradle, the IR port, the charging contacts, the exhaust line connection fitting, and the
gas out to instrument line. The instrument cradle consists of two recessed areas and
is designed to accept the instrument. The recess at the front of the instrument panel
is for instruments that have a Li-ion battery pack installed. Charging contacts are
located at the back of this recess. The recess behind the Li-ion battery pack cradle is
for instruments that have an alkaline battery pack installed. A plastic flap covers the
recess that is not in use. Insert the instrument into the appropriate instrument cradle
recess when you perform a bump test, calibrate, or charge an instrument. An infrared
(IR) port in the front recess lines up with the instrument’s IR port when it is inserted in
either recess and is used to communicate with the instrument. The exhaust line
connection fitting is in the upper left corner of the instrument panel. The exhaust line
is not factory installed and must be installed by the user. An exhaust line storage
fitting is located along the right side of the instrument panel and accepts the fitting at
the end of the exhaust line for storage. The gas out to instrument line is coiled and
stored in a recess in the upper middle portion of the instrument panel.
Alkaline Battery
Pack Cradle
Gas Out to
Instrument Line
Charging Contacts
IR Port
SDM-2012
BUMP CAL. EDIT
ENTER
Exhaust Line
Storage Fitting
COPY
G X-2012 OFF
1SEC ON
3SEC OFF
POWER
CHARGE
Exhaust Line (Must Be
Installed by User)
Lithium Ion Battery
Pack Cradle
Exhaust Line Connection Fitting
Figure 7: Instrument Panel (Shown Without Recess Cover Flap)