RKI Instruments SDM-2012 Standalone Configuration - Manual (Page 97)

Calibration and Bump Test Records • 92
will go into a 5 minute charge cycle and the following screen will be displayed on the
instrument screen.
It will not connect to the docking station. The instrument cannot be bump tested or
calibrated in the charge cycle. Once the 5 minute charge cycle has ended, the unit
will automatically turn back on and connect to the docking station. The unit can now
be bump tested or calibrated.
Calibration and Bump Test Records
The SDM-2012 saves a record of each bump test and calibration performed. It is
capable of saving up to 200 such records. When an SDM-2012’s memory becomes
full, the oldest record is overwritten when a new record is saved. The records saved
in the SDM-2012’s memory can be saved to a USB flash drive using the USB port on
the front.
Available Memory in the SDM-2012
The COPY LED indicates how much of the SDM-2012’s memory has been used. The
table below describes the various indications.
Copying Calibration and Bump Test Records to a USB Flash Drive
The SDM-2012 will only perform a copy operation if there is at least one record saved
in its memory. If there are no records saved in the docking station’s memory, the
COPY LED will be off and the COPY button will not function. Do the following to copy
calibration and bump test records in the SDM-2012’s memory to a USB flash drive.
Table 6: COPY LED Indications
COPY LED Indication Memory Used
Off None. No records are saved
Solid Green Less than 80% of the SDM-2012’s memory
has been used.
Solid Amber More than 80% of the SDM-2012’s memory
has been used.
Solid Red The docking station’s memory is full. A
newly saved record will overwrite the oldest
one.
04.59
CHARGING