Back panel – RKI Instruments SDM-2012 Standalone Configuration User Manual
Page 15
Back Panel • 10
Back Panel
The back panel includes the power jack, sample fittings, and a USB PC connector.
Power Jack
The power jack is located in the bottom left corner of the back panel. The plug on the
end of the AC adapter cable mates to it.
Sample Fittings
Four sample fittings are located on the back of the SDM-2012. The AIR fitting is in the
upper left corner and draws air into the SDM-2012. The two GAS fittings are in the
center of the back panel and are used to connect the SDM-2012 to calibration gas
cylinders. The GAS 1 fitting is above the GAS 2 fitting. All three fittings accept 3/16
inch ID tubing.
An exhaust fitting is located in the upper right corner. It allows routing of the
exhausted calibration gas to a convenient location. This fitting accepts 5/16 inch ID
tubing. Even though the exhaust gas can be routed to an area to be safely dispersed,
the docking station should still be installed in a well ventilated area.
PC Connection
A type B USB connection is located beneath the exhaust fitting on the SDM-2012’s
back panel. It is only used for the PC Controlled configuration and is not used in the
Standalone configuration.
Gas 2 Fitting
Power Jack
Air Fitting
Gas 1 Fitting
Back Panel USB
Port (Type B),
For Computer
Connection
Exhaust Fitting
Figure 10: Fittings and Connections