RKI Instruments SDM-2012 Standalone Configuration - Manual (Page 25)

Setting the Operational Parameters in Edit Mode • 20
instrument is due for calibration, it will show a calibration expired failure
screen and the buzzer and LED arrays will pulse.
The instrument will then connect to the SDM-2012 and display the home
screen shown above in step 6. The CHARGE LED will begin to blink green.
• When CL RMNDR is set to ON and CL EXPRD is set to CONFIRM, if the
instrument is due for calibration, it will show the following screen and beep
and flash the LED arrays for a few seconds indicating that calibration is
due.
When the beeping and flashing stops, press and release the RESET
SILENCE button on the instrument to continue. The instrument will now
connect to the program, the home screen shown in step 6 above will be
displayed, and the CHARGE LED will begin to blink green. If you do not
press and release the RESET SILENCE button to continue, the instrument
will continue to beep and flash the LED arrays every few seconds.
FAIL
C--LIMIT
CAL
C--LIMIT