Rockwell Automation 20D PowerFlex 700 Installation Instructions - Frames 7…10 - Manual (Page 64)

64 Rockwell Automation Publication 20B-IN014H-EN-P - June 2013
PowerFlex 700 Adjustable Frequency AC Drive – Frames 7…10
ALT Functions
To use an ALT function, start at the Main Menu and press the ALT key, release it,
then press the programming key associated with one of the following functions:
Start-Up Routines
The PowerFlex 700 start up routines allow the user to commission the drive more
quickly and accurately. If you have an LCD HIM, two methods are provided.
• S.M.A.R.T. Start
This routine is accessible by using the “ALT” function key on the LCD
HIM. This keystroke brings up a list of parameters needed to program the
eight most commonly adjusted drive functions. These include Start, Stop,
Minimum Speed, Maximum Speed, Acceleration Time, Deceleration
Time, Reference source (speed command) and Electronic Overload setting
for the motor. No knowledge of parameter organization or access is
required. S.M.A.R.T. Start can commission the drive in just a few minutes.
See
page 66 .
ALT Key then Function Function Description
S.M.A.R.T. Displays the S.M.A.R.T. screen. This function allows the drive parameter values to be
quickly programed by directly accessing the most frequently used drive functions.
Refer to the User Manual for more information.
Log In/Out Log in to change parameter settings.
Log out to protect parameter settings.
Change a password.
View Allows the selection of how parameters are viewed or detailed information about a
parameter or component.
Device Select a connected adapter for editing.
Lang Displays the language selection screen. The LCD Human Interface Module (HIM) on
an architecture class drive allows you to change the display language any time.
Auto/Man Switches between Auto and Manual Modes. If the Human Interface Module (HIM)
requests Manual Mode, the Speed Reference source is transferred to the Human
Interface Module (HIM).
Remove Allows Human Interface Module (HIM) removal without causing a fault if the
Human Interface Module (HIM) is not the last controlling device and does not have
Manual control of the drive.
Param # Allows entry of a parameter number for viewing/editing.
ALT
Esc
Esc
Sel
Sel
+/–