Rockwell Automation 20D PowerFlex 700 Installation Instructions - Frames 7…10 - Manual (Page 68)

68 Rockwell Automation Publication 20B-IN014H-EN-P - June 2013
PowerFlex 700 Adjustable Frequency AC Drive – Frames 7…10
Drive Status Indicators & DPI Port Locations
No. Name Color State Description
➊ PWR
(Power) Green Steady Illuminates when power is applied to the drive.
➋ STS
(Status) Green Flashing Drive ready, but not running and no faults are present.
Steady Drive running, no faults are present.
Yellow Flashing, Drive Stopped A start inhibit condition exists, the drive cannot be started.
Check parameter 214 [Start Inhibits].
Flashing, Drive Running An intermittent type 1 alarm condition is occurring.
Check parameter 211 [Drive Alarm 1].
Steady, Drive Running A continuous type 1 alarm condition exists.
Check parameter 211 [Drive Alarm 1].
Red Flashing Fault has occurred. Check [Fault x Code] or Fault Queue.
Steady A non-resettable fault has occurred.
➌ PORT Refer to the Communication
Adapter User Manual. Status of DPI port internal communications (if present).
MOD Status of communications module (when installed).
NET A Status of network (if connected).
NET B Status of secondary network (if connected).
➍
DPI Port 1 HIM connection.
➎
DPI Port 5 Cable connection for communications adapter.
➏
DPI Port 3 or 2 Splitter cable connected to DPI Port 2 provides additional port.
➐
DPI Port 2 Cable connection for handheld and remote options. Located
on side of chassis for Frame 7 IP20, NEMA/UL Type 1.
TB11
TE 25 AMPERES RMS MAXIMUM PORT
NET A
NET B MOD
➊
➋
➌
2
1or3
➍
➐
➏
➊
➋
➌
➎ Important:
Verify metal
ground tab is
bent 90° and is
under the adapter before
tightening screw. After
tightening the screw, verify
that continuity exists
between the head of the
screw and drive ground.