Rockwell Automation 1403-DM_LM_MM Powermonitor II Instruction Sheet - Manual (Page 31)

Installation 2-19
1403-IN001A-US-P
Fiber Optic Cable Assembly Strain Relief
A strain relief feature at the rear of the Display
Module and a wire tie are provided for securing the
fiber optic transmit and receive cable assemblies. Use
the strain relief feature to protect the fiber optic
connections at the rear of the Display Module. Coil
each fiber optic cable into an approximately one inch
diameter loop and secure each loop to the rear of the
Display Module with the wire tie provided per Figure
2.18, Figure 2.19, and Figure 2.20.
Figure 2.18 Fiber Optics Strain Relief
1. Insert the wire tie into the slot on the Display
Module’s rear cover.
Figure 2.19 Fiber Optics Strain Relief
2. Push the wire tie into the slot and force it out of
the second, adjacent slot.
Figure 2.20 Fiber Optics Strain Relief
3. Install and secure both fiber optic cables. The
cables should be coiled into one inch minimum
diameter loops and secured with the wire tie.
Cat. No. Explanation and Accessories
for the Display Module Cat. No. explanation and a
listing of all fiber optic accessories.
Additional Information
For additional information regarding the use of the
Display Module to configure the Master Module,
refer to Chapter 4, General Operation.