Rockwell Automation 1403-DM_LM_MM Powermonitor II Instruction Sheet - Manual (Page 34)

3-2 Maintenance
1403-IN001A-US-P
Figure 3.2 Master Module with Battery Installed
4. Reinstall the access cover plate on the top face of
the Master Module.
5. A command should be issued to reset the real time
clock and clear the battery usage counter via the
Display Module or the Communications Card.
Removal
1. Remove the closure plate on the top face of the
Master Module with extreme caution per Figure
3.1. Electrical power is normally connected to the
Master Module.
2. Gently pull the retaining tab of the battery
extractor from its slot, then unfold and extend the
battery extractor upward or away from the Master
Module as shown in Figure 3.3 to completely
expose the battery in its holder.
3. Gently pull upwards on the battery extractor tab to
remove the battery from its holder per Figure 3.3.
Figure 3.3 Battery Extractor Extended for Battery Removal
!
ATTENTION: Risk of fire or burns.
Do not recharge, disassemble, heat
above 212× F, or incinerate. Keep
battery out of reach of children and in
original package until ready to use.
Dispose of used batteries promptly.
Never put batteries in mouth. If
swallowed, contact your physician or
local poison control center.
!
ATTENTION: Replace battery with
Allen-Bradley Cat. No. 1403-BA
only. Use of another battery may
present risk of fire or explosion.
!
ATTENTION: When installing or
removing the battery within the
Bulletin 1403 Master Module, take
care not to come into contact with
metallic surfaces if power is applied.