Rockwell Automation 1398-PDM-xxx IQ Master Version 3.2.4 for IA-2000 and IQ-5000 Positioning Drive Modules, IQ-55 - Manual (Page 25)

3 Publication 1398-PM601A-EN-P — October 2000
INTRODUCTION
Introduction to IQ Master
About the Allen-Bradley IQ Master Manual
This manual contains the procedures you will need to work with IQ Master software. Throughout this man-
ual, the terms ULTRA Plus, IQ, IQ-Series controller, and controller are used to refer to either an ULTRA
Plus, IQ-2000 or IQ-5000 Positioning Drive Module, or an IQ-550 Position Control Module unless other-
wise specified. The term PDM is used to refer to either an ULTRA Plus, an IQ-2000 or an IQ-5000 Position-
ing Drive Module unless otherwise specified.
The manual is organized into six parts plus appendixes. If you are using ULTRA Plus or IQ-Series equip-
ment for the first time, you should read Parts 1 through 4 completely. Starting in Part 2, it is helpful if you
have an operational ULTRA Plus or IQ-Series controller attached to your PC. As you begin to develop your
programs you will begin using Part 5 as your reference guide. You only need to refer to Part 6 if you are
using a computer, PLC or some other device as a host.