Select devices to verify – Rockwell Automation 1734-IE4S POINT Guard I/O Safety Modules User Manual User Manual
Page 133
Rockwell Automation Publication 1734-UM013J-EN-P - July 2014
133
Configuring Safety Connections between a GuardLogix Controller and POINT Guard I/O Modules on a DeviceNet Network
Chapter 7
To skip the devices listed and continue the verification process for other safety
devices on the network, click Next.
Select Devices to Verify
Choose which devices to verify by using the checkboxes in the Verify column of
the Verify Safety Device Configuration dialog box. You can select only the
devices whose status is Ready to be verified.
If the Show all safety devices checkbox is checked, the dialog box lists all of the
safety devices on the network and shows their current status. If it is unchecked,
which is the default, only devices with the following status are shown:
• Verify FAILED
The upload and compare operation indicated that the configuration in the
device does not match the configuration in the RSNetWorx for DeviceNet
configuration file.
• Ready to be verified
The device is not safety-locked and can be selected for verification.
• Verify not supported
The device is not safety-locked, but the device does not support
verification via the Safety Device Verification Wizard. Consult your user
documentation for information on how to verify this device. Once the
device has been verified, it can be safety-locked by the wizard.