Rockwell Automation 1775-KA PLC-3 Communication Adapter Module User Manual - Manual (Page 199)

Remote Error Codes Received from the
1773-KA Module
Appendix B
BĆ7
Error Error
Code Type Meaning
destination PLC-3 file.
3.The length of the destination file is greater than
65,535 words.
86 reply For PLC/PLC-2 bit write commands:
Keyswitch setting at local PLC-3 processor
prohibits access.
For PLC/PLC-2 word write commands:
Local keyswitch setting prohibits writing into
desired destination file.
For all PLC-3 write commands:
Keyswitch setting disallows access to file.
87 reply For all PLC/PLC-2 read and write commands:
The local PLC-3 processor is in program mode.
There may or may not be a major system fault.
For all PLC-3 read and write commands:
The local PLC-3 processor is in program mode.
There may or may not be a major system fault.
91 Local Handshaking lines on the RS-232-C link are not
connected properly.
92 local The remote station specified does not acknowledge
(ACK) the message.
94 local Local port is disabled through LIST.
112 local 1.Undefined assignment operator in an assignment
statement.
2.Undefined operator in an expression.
114 local Illegal expression syntax.
115 local Illegal unary (prefix) operator in an expression.
117 local Undefined data following a valid address in a
CREATE command, or undefined data following a
valid symbol in a DELETE command.
121 local Symbol undefined. This will occur if a symbol
appears as the source in an assignment command
before it is defined as a symbol. For example, a
statement of the form A = A + 6 will give this error
if user symbol 'A' has not appeared previously.
123 local System symbol must be a symbolic address. This