Rockwell Automation 1775-KA PLC-3 Communication Adapter Module User Manual - Manual (Page 32)

Installation
Chapter 2
2Ć20
Figure 2.11
LIST Menu for 1775-KA Module
System Mode
1 Test–Monitor
2 Run Monitor
3 Program Load
4 Remote Enable
5 System Status
6 *Module Status
Enter Next >
Modules
1 01
1775–ME8 A/A
1775–ME8 A/A
1775–L3 A/A
1775–S4A B/A
1775–KA A/E
1775–LX A/A
1775–LX A/A
1775–S4B B/A
1775–S4B B/A
2 02
3 03
4 04
5 05
6 06
7 07
8 08
9 09
ENTER NEXT >
Data Hwy Comm
Adapter – 01
Chassis 0 Slot 0
1 Module Options
2 Data Highway Port
3 Modem Port
Enter Next >
KA–01 Data Highway Port
1 Enable/Disable Port
2 Station Number
3 Baud Rate
Enter Next >
KA–01 Modem Port
1 Enable/Disable Port
2 Station Number
3 Baud Rate
4 Communication Mode
5 Even Parity
6 *Send Embedded
Responses
Enter Next >
KA–01 Module Options
1 Timeout
2 *Send Unprotected
3 Accept Upload/Download
4 Accept Writes
5 Backup Operation
6 PLC–2 Mask
ENTER NEXT >
KA–01 Module Options
Timeout
Enter Timeout >
KA–01 Data Highway Port Enable
1 Enable
2 *Disable
Enter Next >
KA–01 Data Highway Port
Station Number
Enter Station Number >
KA–01 Data Highway Port Baud Rate
1 38400
2 *57600
Enter Next >
KA–01 Modem Port Enable
1 Enable
2 *Disable
Enter Next >
KA–01 Modem Port
Station – 377
Enter Station Number >
KA–01 Modem Port Baud Rate
1 110
2 300
3 600
4 *1200
5 2400
6 4800
7 9600
8 19200
Enter Next >
KA–01 Modem Port Communication Mode
1 *Unpolled Mode
2 Polled – Subscriber Mode
Enter Next >
Toggle selection – select this number to enable
or disable the option.
NOTE: Those selections shown in bold type affect
the operation of the module; the LIST display
shows an asterisk (*) to indicate when an
option is enabled. The selections not shown in
bold type only cause a movement to another level
of LIST. This selections indicated in this figure are
selected by default at the initial power–up.
= 50/10 sec
= 377
1
1
1
1
1
1
1
1
10012–I