Rockwell Automation 1746-HSCE,D17466.5 High-Speed Counter Module - Manual (Page 113)

1 Publication 1746-UM006B-EN-P - August 2005
Chapter
6
Application Examples
This chapter contains the following application examples:
•
a basic count-only example using the Rate Mode
•
supplementary examples that represent the Range, Rate, and
Sequencer Modes
Basic Count-Only Example This basic example is provided to get you started using the
High-Speed Counter module. This Count-Only example demonstrates
how to configure your module to read the number of accumulated
pulses from an encoder or other high-speed device, and apply this
information to your ladder program. Refer to Timing Information in A.
Configure slot 1 for the High-Speed Counter module and slot 2 for an
input module as shown below.
IMPORTANT
Appendixes D and E contain blank worksheets to
assist you when configuring your module. Appendix
D contains worksheets for Range and Rate Mode
operation. Appendix E contains worksheets for the
Sequencer Mode operation.
SLC 5/02
Processor High-Speed Counter
Module
Motor
Encoder A+A B+B
Input Module
Reset Push Button