Rockwell Automation 1756-IH16ISOE ControlLogix Sequence of Events Module - Manual (Page 41)

1 Publication 1756-UM528A-EN-P - April 2004
Chapter
4
Configuring the Sequence of Events Module
What This Chapter
Contains This chapter describes how to configure your Sequence of Events
module.
Configuring Your I/O
Module You must configure your module upon installation. The module
will not work until it has been configured with at least the default
configuration.
RSLogix 5000 Configuration Software
You must use RSLogix 5000, version 13 to set configuration for
your Sequence of Events module. You have the option of accepting
default configuration for your module or writing point level
configuration specific to your application.
Both options are explained in detail, including views of software
screens, in this chapter.
Table 4.1
For information on: See page:
Configuring Your I/O Module 4-1
Overview of the Configuration Process 4-2
Adding a New Module to Your RSLogix 5000 Project 4-3
Using the Default Configuration 4-6
Altering the Default Configuration 4-6
Downloading Configuration 4-7
Editing Configuration 4-7
Configuring Modules in a Remote Chassis 4-9
IMPORTANT
This chapter focuses on configuring I/O modules in
a local chassis. To configure I/O modules in a
remote chassis, you must follow all the detailed
procedures with two additional steps. To see the
additional steps, see page 4-9.