Rockwell Automation 1756-IH16ISOE ControlLogix Sequence of Events Module - Manual (Page 58)

Publication 1756-UM528A-EN-P - April 2004
5-6 Using the Sequence of Events Module Features
Use the Configuration tab in RSLogix 5000 to set Enable CST
Capture, as shown in the example below.
Click the Configuration tab.
• Click on the individual boxes for
each input point to enable CST
Capture for that point.
• Clear the individual boxes for
each input point to disable CST
Capture for that point.
You can also use these boxes to enable
or disable all points simultaneously.
IMPORTANT
The basic function of Enable CST Capture (i.e.,
timestamp specific input transitions) occurs
whether the Sequence of Events module is used in
CST Per Point mode or FIFO mode. However, how
the module uses the data from each transition
varies slightly depending on the mode in which
the module is operating.
• For more information on how Enable CST
Capture is used in CST Per Point mode, see
page 6-7.
• For more information on how Enable CST
Capture is used in FIFO mode, see page 7-9.