Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 15)

Rockwell Automation Publication 1783-UM005A-EN-P - September 2013 15
Chapter
2
Install Stratix 5900 Services Router
This chapter explains how to install and connect the Stratix 5900 services router.
This router supports Ethernet communication from component to component.
It has a chassis for use in industrial automation and harsh environments.
Topic Page
Install the Unit 17
Install the Router on a DIN Rail 17
Installation Clearance 18
Prevent Damage to the Router 18
Ground the Router 18
Connect a Personal Computer, Server, or Workstation 19
Connect an External Ethernet Switch 20
Connect a Terminal or Computer to the Console Port 21
Terminal Emulator Application Settings 22
Connecting a Modem to the Console Port 22
Apply Power 23
Assemble the On/Off Power Lock 25
Verify Connections 26
ATTENTION:
• Before installing, configuring, operating, or maintaining this product, read this document and the documents listed in the
Additional Resources section for installing, configuring, or operating equipment. Familiarize yourself to the installation and wiring
instructions in addition to requirements of all applicable codes, laws, and standards.
• Installation, adjustments, putting into service, use, assembly, disassembly, and maintenance shall be carried out by suitably
trained personnel in accordance with applicable code of practice. In case of malfunction or damage, no attempts at repair can be
made. The product can be returned to the manufacturer for repair. Do not dismantle the module.
• If this equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment can be
impaired.
• This equipment is certified for use only within the surrounding air temperature range of -25…60 °C (-13…140 °F). The
equipment must not be used outside of this range.
ATTENTION: When installing the product, use the provided or designated connection cables/power cables/AC adapters. Using any
other cables/adapters could cause a malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of UL-
certified cables (that have the `UL’ shown on the code) for any other electrical devices than products designated by CISCO. The use
of cables that are certified by Electrical Appliance and Material Safety Law (that have `PSE’ shown on the code) is not limited to
CISCO-designated products.