Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 36)

36 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 3 Configure the Stratix 5900 Services Router
Stratix 5900 Device Manager
Software Wizard The configuration wizard appears the first time you turn on your services router
and communicate with it by using an IP address. The wizard guides you through
the essential parts of the router configuration so that the router can start
functioning on the network.
Figure 1 - Example Stratix 5900 Device Manager Software Wizard Dialog Box
To reactivate the wizard, reset the router to the factory default settings. See Reset
the Services Router on page 26 for more information.
To use the wizard, perform the following steps:
1. Open a web browser on the computer, disable any active popup blockers,
and enter the following URL:
http://10.10.10.1
Stratix Configurator software runs in Firefox, Google Chrome, and
Internet Explorer. If you are going to use Internet Explorer, it must be
version 9.0 or later.
2. Enter the username cisco, and the password cisco in the login window. If
other login windows appear during the startup process, enter the same
credentials (cisco/cisco).
TIP If the launch page does not appear when you enter the URL http://10.10.10.1,
test the connection between the computer and the router by doing the
following:
• Check that the Power to the router is on, and that the status indicator for
the port that the computer is connected to is on, indicating an active
Ethernet connection between the router and the computer. If this status
indicator is not lit, verify that you are using a crossover cable to connect the
computer to the router, or that you are using a straight-through cable
between the router and the switch.
• Verify that the web browser work offline option is disabled. In Internet
Explorer, click the File menu, and verify that the work offline option is
unchecked.
• Verify that the files cpexpress.tar, home.tar, and home.shtml files are
loaded into nonvolatile memory. Open a Telnet session to 10.10.10.1,
entering the username cisco and the password cisco. Enter the show flash
command to display the files that are loaded in nonvolatile memory.