Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 50)

50 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 3 Configure the Stratix 5900 Services Router
Summary Window The Summary dialog box shows you the changes you have made to the router
configuration and the associated CLI commands that are sent to the router.
You can do these tasks on the Summary dialog box.
• Click cancel to go back and make changes.
• Click Deliver the settings to the router.
• Click Save to file to save the configuration file.
Configuring a Wide Area
Network Interface With Stratix 5900 Device Manager software, you can configure one wide area
network (WAN) interface.
WAN Interface Selection
If your router has multiple WAN interfaces, choose the interface that you want to
configure in this window.
1. Choose the interface you want to configure from the list.
2. Click Configure.
3. Go to Interfaces and Connections.
4. Click Create New Connection.
5. Check Ethernet (PPPoE or Unencapsulated Routing).
6. Click Create New Connection again.
The WAN Wizard appears.
7. Follow the instructions in the Wizard.
TIP If you do not configure a WAN connection, you cannot configure a firewall,
routing, Cisco Network Services, or SDP.