Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual User Manual
Page 79
Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
79
Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI)
Chapter 4
!
no ip routing
!
interface FastEthernet0
no shutdown
speed 100
duplex auto
ip address 172.16.2.3 255.255.0.0
!
12. Respond to the following prompts. Enter 2 to save the initial
configuration.
[0] Go to the IOS command prompt without saving
this config.
[1] Return back to the setup without saving this
config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify
this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
13. Verify the initial configuration. See
Discover the Router on page 41
.