Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 78)

78 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 4 Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI)
7. Enter an enable password that is different from the enable secret password.
This password is not encrypted (less secure) and can be seen when viewing
the configuration.
The enable password is used when you do not specify
an enable secret password, with some older software
versions, and some boot images.
Enter enable password: xxxxxx
8. Enter the virtual terminal password, this prevents unauthenticated access
to the router through ports other than the console port.
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: xxxxxx
9. Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces is displayed.
10. Choose one of the available interfaces for connecting the router to the
management network.
Enter interface name used to connect to the
management network from the above interface
summary: fastethernet4
11. Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] :
255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits;
mask is /16
The configuration is displayed:
The following configuration command script was
created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public