Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual User Manual
Page 77
Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
77
Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI)
Chapter 4
The prompts in the setup command facility vary, depending on your
router model, on the installed interface modules, and on the software
image. The following steps and the user entries (in bold) are shown only as
examples.
3. To proceed using the setup command facility, enter yes.
Continue with configuration dialog? [yes/no]: yes
4. When the following messages appear, enter yes to enter basic management
setup.
At any point you may enter a question mark '?' for
help.
Use ctrl-c to abort configuration dialog at any
prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough
connectivity for management of the system, extended
setup will ask you to configure each interface on
the system
Would you like to enter basic management setup?
[yes/no]: yes
5. Enter a hostname for the router (this example uses Router).
Configuring global parameters:
Enter host name [Router]: Router
6. Enter an enable secret password.
This password is encrypted (more secure) and cannot be seen when
viewing the configuration.
The enable secret is a password used to protect
access to privileged EXEC and configuration modes.
This password, after entered, becomes encrypted in
the configuration.
Enter enable secret: xxxxxx
TIP
If you make a mistake while using the setup command facility, you can
exit and run the setup command facility again. Press Ctrl-C and enter
the setup command at the privileged EXEC mode prompt (Router#).
For more information on using the setup command facility, see `The
Setup Command’ chapter in
.