Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 26)

26 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 2 Install Stratix 5900 Services Router
Verify Connections Follow these instructions to verify that all devices are properly connected to the
router.
1. Turn on all the connected devices.
2. Check the status indicators.
3. Use this table to verify the router operation. For complete status indicator
descriptions, see Status Indicators on page 11 .
Reset the Services Router The Reset button resets the router configuration to the default configuration set
at the factory.
Follow these instructions to reset router configuration to the default
configuration.
1. Locate the Reset location on the services router.
2. Using a standard size #1 paper clip (wire gauge 0.033 inch or smaller),
simultaneously press the reset button while applying power to the router.
3. Keep the reset button pressed for five seconds after applying power.
Power and Link Status Indicator Normal Patterns
SYS Yellow FPGA download is complete.
Green (blinking) ROMMON is operational.
Off After powering up, when FPGA is being downloaded (in ROMMON).
ACT Green Network activity on FE Switch ports, GE WAN port, and serial
interfaces.
Off No network activity.
EN Green when the interface is up.
S S Blinking green indicates port speed. Slow blinking for 100Base SFPs
and fast blinking for 1000Base SFPs.
RESET
SERIA
SYS
ACT
32380-M