Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 16)

16 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 2 Install Stratix 5900 Services Router
ATTENTION: Read the DIN-rail mounting instructions carefully before beginning installation. Failure to use the correct hardware
or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
• The covers are an integral part of the safety design of the product. Do not operate the unit without the covers installed.
• No user-serviceable parts inside. Do not open.
• Hot surface.
ATTENTION: To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV)
circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ45 connectors.
Use caution when connecting cables.
ATTENTION: Installation of the equipment must comply with local and national electrical codes.
• Read the installation instructions before connecting the system to the power source.
• To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN
ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ45 connectors. Use caution
when connecting cables.
• This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that
suitable grounding is available.
• When installing or replacing the unit, the ground connection must always be made first and disconnected last.
• Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or
near a swimming pool.
IMPORTANT At the end of its life, collect this equipment separately from any unsorted municipal waste.
IMPORTANT This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and
legal requirements can apply for direct connection to the Cable Distribution System. This product can connect to the Cable
Distribution System only through a device that is approved for direct connection.
ATTENTION: This equipment is sensitive to electrostatic discharge, which can cause internal damage and affect normal
operation. Follow these guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation, if available.
• Store the equipment in appropriate static-safe packaging when not in use.
IMPORTANT When the router is installed in an industrial enclosure, the temperature within the enclosure is greater than normal room
temperature outside the enclosure.
The temperature inside the enclosure must not exceed 60 °C (140 °F), the maximum ambient enclosure temperature of the
router.