Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 76)

76 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 4 Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI)
5 minute output rate 0 bits/sec, 0 packets/sec
1012272 packets input, 91255488 bytes, 0 no buffer
Received 916 broadcasts, 0 runts, 0 giants
18519 input errors, 0 CRC, 17796 frame, 0 overrun,
0 ignored, 723 abort
283132 packets output, 13712011 bytes, 0 underruns
0 output errors, 0 collisions, 31317 interface
resets
0 output buffer failures, 0 output buffers swapped
out
3 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Setup Command Facility
The setup command facility guides you through the configuration process by
prompting you for the specific information that is needed to configure your
system. Use the setup command facility to configure a hostname for the router, to
set passwords, and to configure an interface for communication with the
management network.
To use the setup command facility, you must set up a console connection with the
router and enter the privileged EXEC mode.
To configure the initial router settings by using the setup command facility,
follow these steps:
1. Set up a console connection to your router, and enter privileged EXEC
mode.
For instructions on how to enter privileged EXEC mode, CLI
Architecture on page 60 .
2. In privileged EXEC mode, at the prompt, enter setup.
yourname# setup
The following message is displayed:
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in the setup command facility.