Rockwell Automation 6181 Industrial Computer - Manual (Page 139)

Using a Touchscreen C–3
Publication 6181-UM001D-EN-P
To calibrate the touchscreen:
1. Locate the Elo calibration utility in the Control Panel or insert the
touchscreen driver diskette in the floppy drive of the RAC6181
Computer.
2. Using the appropriate commands for your operating system, run the
Elo calibration utility.
3. Follow the instructions in the Elo calibration utility to complete the
calibration process.
The touchscreen requires the following types of maintenance:
Routine Cleaning
Clean the surface of the touchscreen with any glass cleaning solution and
a soft, nonabrasive cloth.
Note: Because the touchscreen is pressure-sensitive, directing a
strong flow of water at the touchscreen during a washdown
may activate the touchscreen.
Performing Field Service
If you must perform field service on the RAC6181 Computer, ensure that
you plug the touchscreen cable into the controller board with the proper
orientation:
Maintenance