Rockwell Automation 6181 Industrial Computer - Manual (Page 41)

Initial Operation and Setup 3–5
Publication 6181-UM001D-EN-P
Initial Startup and Service Packs
The initial system startup begins with the NT operating system at Service
Pack 1, and enters Window NT Workstation Setup. During setup, the
system is built, the drivers and applications are installed, user
information is gathered via the start-up dialogs. At the end of setup, the
current Service Pack is automatically installed and is visible when the
system is restarted.
Installing device drivers alters the system and the current service pack
should be re-installed by running the update tool. For example, if the
current Service Pack is SP4, the update tool is
c:\sources\SP4\i386\update\update.exe.
The 6181 display-only computers require an EloTouch Systems touch
screen driver. The 6181 12.1 inch keypad bezel computers use a
Touchko touch screen application.
EloTouch Systems Drivers
The touch screen drivers for the EloTouch Systems touchscreen are not
pre-installed for Windows 2000. The first time you apply power to the
6181 Computer, you must complete the following steps to finish the
touchscreen driver installation.
1. When you log on to Windows 2000 for the first time after
completing the 6181 power-up, follow the prompts that are displayed
to install the touchscreen driver.
2. When the touchscreen installation procedure displays the following
screen, select COM2. The 6181 touchscreen is internally connected
to the COM2 port on the CPU card.
Installing a RAC6181
Computer Touchscreen
Driver