Rockwell Automation 6181 Industrial Computer - Manual (Page 60)

6–2 Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay
Publication 6181-UM001D-EN-P
These instructions describe how to remove the drive bay and replace the
hard drive or floppy drive.
To remove the drive bay:
1. Disconnect power from the RAC6181 Computer.
ATTENTION: Disconnect all power from the RAC6181
Computer before adding or removing components.
Failure to disconnect power could result in severe
electrical shock or damage to the RAC6181 Computer.
2. Remove the back cover of the RAC6181 Computer. Refer to
procedures in Chapter 4 for details on how to remove the back cover.
3. Remove the drive bay.
4. Disconnect the ribbon cable connector and the power connector from
the hard drive and floppy drive.
5. Remove the hard drive from the drive bay (4 screws).
Installing/Removing a
Hard Drive or Floppy
Drive