Rockwell Automation 6181 Industrial Computer - Manual (Page 50)

4–6 Adding/Removing System Components
Publication 6181-UM001D-EN-P
To install a CPU or add-in card:
1. Remove the board from its anti-static packaging and place on a
grounded, static free surface.
2. Set any board jumpers or switches as described in the instructions for
the board.
Note: If you are replacing the CPU card, make careful note of
the cables attached to the existing CPU card so that you
can reconnect the cabling to the new card.
ATTENTION: The Pentium and Pentium III CPU cards
each contain a video jumper setting specific to each
version of the RAC6181 Computer with a display. If this
jumper is set incorrectly, the RAC6181 video circuitry
may be damaged.
12.1" Display
12.1" Display
10.4" Display
10.4" Display
Jumper Settings
Jumper Settings
Jumper JP2
Jumper JP1
Pentium CPU Card Pentium III CPU Card
Note: For non-display units, this jumper can be set to either
setting.
ATTENTION: If you have a 2-slot RAC6181 Computer
and you are installing a Pentium III CPU, you must install
SODIMM memory modules before placing the CPU card
into the slot. For instructions about how to remove and
install memory modules, see Chapter 8,
Installing/Removing Memory Modules.