Rockwell Automation 6181 Industrial Computer - Manual (Page 86)

10–4 12.1 in. Keypad Bezel Operation
Publication 6181-UM001D-EN-P
12. To reassemble the front bezel assembly, thread the keypad and
touchscreen cables through the hole in the metal frame.
13. Reconnect the keypad cable, touchscreen cable, backlight tube
connectors, and backlight power supply cable.
14. Reinstall the 10 screws to attach the metal frame to the plastic
overlay assembly. Tighten the screws to a torque of 6 – 8 in-Lbs (0.7
– 0.9 N•m).
15. Attach the bezel and install the hinge retainer screw.
16. Reinstall the 6 adapter plate screws. Tighten the screws to a torque
of 6 – 8 in-lbs. (0.7 – 0.9 N•m).
17. Reinstall the computer in the panel
The RAC6181 Keypad Configuration Utility (KCU) is a PC-based
program that allows you to modify, view, print, and save keypad
configurations for the 6181 12.1 inch keypad bezel. The keypad
configuration can then be downloaded to the 6181 12.1 inch keypad
Bezel Interface Controller (BIC) Card using a DOS-based jflash.exe
utility.
For each keypad configuration you can:
•
Enable or disable specific keys or selected key combinations.
•
Configure the key functionality.
•
Retrieve, modify, and save key codes associated with specific keys on
the computer’s bezel.
The resultant codes for single key are often referred to as the definition
or mapping of the key. The collection of all keys’ definitions is
commonly called the Keypad Configuration.
Hint: If you modify the Keypad Configuration, you should save
the new configuration to a Keypad Configuration File
(*.KY3). This file can be downloaded into another 6181
computer to provide the same keypad behavior, or used to
reload the desired configuration into a replacement 6181
computer.
Setting Up and Using the
Keypad Configuration
Utility Software