Rockwell Automation 6181 Industrial Computer - Manual (Page 63)

Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay 6–5
Publication 6181-UM001D-EN-P
These instructions describe how to install the optional 5.25-in. drive
expansion bay (6189-1EXPBAY) on the RAC6181 Computer. The
expansion bay can be used to house additional components such as a
DVD-ROM or Read/Write CD-ROM drive.
Installing the expansion bay involves the following procedures:
•
Removing the existing back cover
•
Exchanging the IDE ribbon cable used for the existing hard drive
with the new cable supplied with the expansion bay option
•
Installing the drive in the expansion bay
•
Installing the expansion bay as the new back cover
To exchange the hard drive and floppy drive cables:
1. Disconnect power from the RAC6181 Computer.
ATTENTION: Disconnect all power from the RAC6181
Computer before adding or removing components.
Failure to disconnect power could result in severe
electrical shock or damage to the RAC6181 Computer.
2. Remove the back cover and top cover of the RAC6181 Computer.
Refer to procedures in Chapter 4 for details on how to remove the
back cover and top cover.
3. Partially remove the CPU card, I/O card, and any add-in boards so
that you can access the IDE connector that connects to the hard drive
and floppy drive. Refer to procedures in Chapter 4 for details on
removing add-in cards.
4. Disconnect the IDE ribbon cable from the CPU card that leads to the
hard drive and floppy drive and connect the replacement IDE ribbon
cable.
5. Remove the drive bay.
6. Disconnect the ribbon cable from the hard drive and floppy drive and
connect the replacement ribbon cable. The middle connector
attaches to the hard drive.
Note: Make sure that the ribbon cable is installed correctly.
The connector must be positioned so that the red wire
of the cable is closest to the back of the unit.
Installing/Removing an
Expansion Bay