Rockwell Automation 6181 Industrial Computer - Manual (Page 65)

Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay 6–7
Publication 6181-UM001D-EN-P
To install the drive in the expansion bay:
1. Feed the power cable and ribbon cable through the slot on the
bottom of the expansion bay.
2. Connect the power cable and ribbon cable to the expansion drive.
Note: If you are installing a CD-ROM drive, ensure that the
jumper setting on the CD-ROM drive is set to "Slave."
3. Secure the drive to the expansion bay using the four screws
provided.
To install the expansion bay on the RAC6181 Computer:
1. Position the ribbon cable and power cable inside the unit to ensure
that:
•
The cables do not obstruct the air flow around the internal fan.
•
The cables will not be pinched when you secure the expansion
bay cover to the unit.
2. Secure the expansion bay to the back of the RAC6181 Computer
using seven of the screws from the original cover.
ATTENTION: Be careful not to push the vibration
dampers (grommets) on the drive bay out of the sheet
metal.
3. Apply power and verify the operation of the drive. Refer to any
additional instructions provided with the drive.
To remove the expansion bay:
1. Disconnect power from the RAC6181 Computer.
ATTENTION: Disconnect all power from the RAC6181
Computer before adding or removing components.
Failure to disconnect power could result in severe
electrical shock or damage to the RAC6181 Computer.
2. Remove the screws that secure the expansion bay (back cover) to the
RAC6181 Computer. Refer to procedures in Chapter 4 for details on
how to remove the back cover.