Rockwell Automation 6181 Industrial Computer - Manual (Page 61)

Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay 6–3
Publication 6181-UM001D-EN-P
To install the drive:
1. Install the hard drive in the drive bay (4 screws)
2. Connect the ribbon cable connector and power cables to the hard
drive and floppy drive.
Note: Make sure that the ribbon cable is installed correctly.
The connector must be positioned so that the red wire
of the cable is closest to the back of the unit.
3. Position the drive bay into the chassis so that the studs on the chassis
fit into the grommets on the drive bay.
ATTENTION: Be careful not to push the vibration
dampers (grommets) on the drive bay out of the sheet
metal.
4. Install the back cover.
5. Apply power and verify the operation of the drive. Refer to any
additional instructions provided with the drive.