Rockwell Automation 6181 Industrial Computer - Manual (Page 81)

Replacing the Backlight Tubes 9–9
Publication 6181-UM001D-EN-P
Replacing the backlight tubes:
1. Remove the 2 screws holding each backlight tube in place.
Backlight Screws
Display Cable
Retaining
Screws
Backlight Screws
Backlight
Retaining Tabs
Backlights
are shaded
in gray.
2. Slide the tube to the right about 1/8 in. (3 mm) and gently pull the
tube up and out of the assembly.
3. Insert the replacement backlight tube into the slot and slide it to the
left until the holes for the screws are aligned.
4. Replace the screws that hold the backlight in place.
Reinstalling the flat panel display:
1. Carefully pivot the chassis back into place on the display assembly.
2. Reattach the following connectors:
•
Keyboard connector cable
•
Backlight power/LED cable
•
Touchscreen cable (if applicable)