Rockwell Automation 6181 Industrial Computer - Manual (Page 64)

6–6 Installing/Removing the Hard Drive, Floppy Drive, or Expansion Bay
Publication 6181-UM001D-EN-P
7. Disconnect the existing power cable attached to the hard drive.
8. Connect the power cable to the appropriate connector of the
Y-shaped power cable provided with the expansion bay kit. Connect
the other connector to the hard drive.
9. Leave hard drive jumper in default setting (Master).
10. Position the drive bay into the chassis so that the studs on the chassis
fit into the grommets on the drive bay.
ATTENTION: Be careful not to push the vibration
dampers (grommets) on the drive bay out of the sheet
metal.
11. Reinstall the CPU card and any add-in boards and replace the top
cover.